Darware Metal Wall Ring Planters with Pots (4-Pack, 8-Piece Set); Wall Mounted Clay Pots with Holders for Plants and Flowers

Why I tried these wall ring planters

I had a blank stretch of fence crying out for some green, but I didn’t want bulky boxes or anything that would turn watering into a chore. These wall ring planters hit the sweet spot: small terra-cotta pots in minimalist black rings that mount right to a wall or post. I installed a set of four to see how they’d handle herbs and succulents outdoors and a pair indoors next to a sunny window.

What’s included and how they’re built

The set consists of four black metal rings and four 4-inch terracotta pots. The rings are 4 inches in diameter and welded to a slim mounting plate that’s roughly 1 inch wide by 3.25 inches tall. The steel feels stout for the size—lightweight but not flimsy—and the coating on my set was smooth and even, with no sharp burrs at the welds.

The terracotta is classic, slightly porous clay with a traditional lip. Each pot measures about 4 inches tall, roughly 4.25 inches at the widest point, a 4-inch top opening, and a 2.5-inch base. Capacity is about 1 3/4 cups—small, but appropriate for the scale. All four pots arrived unchipped and uncracked, and the interiors were clean. My pots came with a single drainage hole, which is what you want for outdoor use.

This size is ideal for succulents, small trailing plants, and compact herbs. It is not the vessel for thirsty annuals or anything root-happy—think thyme, sedum, echeveria, string-of-pearls, baby tears, or mini peperomia.

Installation: quick, with a couple of caveats

Mounting is straightforward. The base plate has pre-drilled holes. On a cedar fence, I drove two 1-inch exterior wood screws straight into the board. For drywall, I used 25-pound-rated anchors; for masonry, masonry screws into pre-drilled holes. If your set doesn’t include hardware or you’re mounting into anything other than wood, plan on sourcing proper anchors.

Two practical notes:
- Use low-profile pan or flat-head screws. If the head stands proud, the pot’s shoulder can catch when you slide it into the ring. Flush hardware avoids that annoyance.
- Level matters. The round ring makes it easy to get slightly off. I pre-punched a pilot mark and used a torpedo level before sinking the second screw.

From unboxing to planted, my first set of four took under 30 minutes.

Fit, stability, and day-to-day use

The pots sit snugly in the 4-inch rings with a reassuring friction fit. There’s no latch, but the combination of the pot’s taper and the ring’s diameter keeps everything stable. I gave them a few firm taps and tugged on them after watering; no rattling or shift. That said, I wouldn’t mount them where a ball or door could smack into them—terracotta is terracotta.

If you want belt-and-suspenders insurance on a breezy porch, a discreet clear silicone bump on the backside of the pot lip (or a tiny rubber O-ring on the ring) quiets any micro-movement.

Planting performance

This is terracotta, so it wicks moisture and breathes. In full sun, that means quicker dry-down; in shade or indoors, more forgiving humidity. The small volume (about 1 3/4 cups) keeps the weight low but also means you need to be thoughtful with media and plant choice:

• Succulents: A gritty cactus mix and a top-dressing of gravel kept my echeveria happy; water deeply, then let it dry completely. Outdoors in summer, that was every 5–7 days.
• Herbs: Thyme and oregano handled the confined space well. Basil struggled—the pot is just too small and dries too quickly in afternoon sun.
• Trailers: String-of-pearls and sedum burrito looked great cascading over the rings, and the black steel frames them nicely.

Because water will drip, these are best outdoors or on a surface you don’t mind getting damp. For indoor use above finished walls, I lined the pots with thin nursery cups (with holes) so the clay doesn’t weep as much and used a saucer on the floor below during watering.

Durability outdoors

After a few weeks outside, the steel rings show no flex or sag even with fully saturated soil. The coating has handled watering and a couple of light rains without any chalking or rust blooms. Terracotta will patina over time; if you want to slow the white mineral bloom, use filtered water or wipe the pot sides periodically with diluted vinegar, then rinse.

The weld between ring and base is the only stress point worth watching. I inspected each piece before installation; welds looked clean and consistent. With a pot this small, the load is minimal, and I didn’t observe any bending.

Design and aesthetics

The look is restrained and versatile: a slim black circle framing warm, earthy clay. It plays well with farmhouse, modern, and vintage spaces, especially when repeated in a grid or staggered line. I mounted three in a vertical column on a fence board and a fourth offset to break the rhythm; it reads like a simple plant installation rather than a random scattering of pots.

Because the ring holds the pot close to the wall, the silhouette is neat, and the plants feel integrated with the surface rather than jutting out. If you plan to mix sizes, just note these are scaled to 4-inch pots; larger pots will not fit these rings.

Where they shine (and where they don’t)

What they do well:
- Quick, low-profile greenery on fences, porch posts, and accent walls
- A tidy way to display succulents and small herbs without a full planter box
- Cohesive look when repeated—clean circles and warm clay are an easy design win

Limitations to keep in mind:
- Small volume means more frequent watering in hot, dry conditions
- Terracotta is brittle; avoid high-traffic areas or where it could be knocked loose
- Pot insertion can bind if your mounting screws aren’t flush; clearances are tight by design
- Not intended for heavier or larger pots; stick to the 4-inch size included

Tips for best results

• Pre-fit a pot in a ring on your workbench before mounting. It helps you visualize screw placement and clearance.
• Use low-profile exterior screws and drive them fully flush.
• For drywall, choose anchors rated at least 25 pounds. For brick or stucco, use proper masonry anchors.
• If planting indoors, drop a thin plastic nursery liner inside the terracotta to reduce seepage, and add a coffee filter over the drainage hole to keep soil from escaping.
• Pre-soak new terracotta for 10–15 minutes before potting to prevent the pot from pulling moisture from the soil immediately.
• Choose plants to match exposure: succulents for full sun, fine-leaved herbs for morning sun or bright shade, trailing plants for visual movement.

The bottom line

These wall ring planters are a simple, well-executed way to bring small-scale planting to vertical surfaces. The steel rings are sturdy for their size, the finish is clean, and the included terracotta pots fit correctly and look right at home. Installation is easy if you use the right hardware and keep screw heads flush. The format rewards thoughtful plant selection and a light hand with watering, and it excels when repeated in a pattern.

I recommend this set if you want a compact, minimalist solution for herbs, succulents, or small trailing plants on fences, porch posts, or accent walls. You’ll get a tidy, cohesive look with solid build quality, provided you’re comfortable with the small pot size and the extra watering that terracotta demands in hot weather.